[1] IEA (2022), Transport sector CO2 emissions by mode in the Sustainable Development Scenario, 2000-2030, IEA, Paris https://www.iea.org/data-and-statistics/charts/transport-sector-co2-emissions-by-mode-in-the-sustainable-development-scenario-2000-2030
[2] International Organization of Motor Vehicle Manufacturers, 2018 Production Statistics. Available from: http://www.oica.net/category/production-statistics/2018-statistics/ (accessed 23 April 2019)
[3] Heywood J.B., Internal Combustion Engine Fundamentals, McGraw-Hill, 1988.
[4] Javani N., Dincer I., Naterer G.F., et al., Heat transfer and thermal management with PCMs in a Li-ion battery cell for electric vehicles. International Journal of Heat and Mass Transfer, 2014, 72: 690–703.
[5] Jansen A.N., Dees D.W., Abraham D.P., et al., Low- temperature study of lithium-ion cells using a LiySn micro-reference electrode. Journal of Power Sources, 2007, 174(2): 373–379.
[6] Jeon D.H., Baek S.M., Thermal modeling of cylindrical lithium-ion battery during discharge. Energy Conversion and Management, 2011, 52(8–9): 2973–2981.
[7] Zhang T., Gao C., Gao Q., et al., The development and validation of a thermal model for the cabin of a vehicle. Applied Thermal Engineering, 2015, 88: 398–409.
[8] Ma S., Jiang M., Tao P., et al., Temperature effect and thermal impact in lithium-ion batteries: A review. Progress in Natural Science: Materials International, 2018, 28(6): 653–666.
[9] Lyu P., Liu X., Qu J., et al., Recent advances of thermal safety of lithium-ion battery for energy storage. Energy Storage Materials, 2020, 31: 195–220.
[10] Haghanimanesh M., Baniasadi E., Kerdabadi J.V., et al., Exergoeconomic analysis of a novel trigeneration cycle based on steel slag heat recovery and biogas production in steelmaking plants. Energy Conversion and Management, 2022, 263(1): 115688.
[11] Kerdabadi J., Haghanimanesh M., Karimipour A., et al., The experimental/numerical investigation of variations in strip speed, water shower pattern and water temperature on high-temperature strip cooling rate in hot strip mill. Journal of Thermal Analysis and Calorimetry, 2021, 143: 293–308.
[12] Zeng X., Huang Y., Song D., et al., Design and research on the thermal management integrated control system of BEV based on heat pump air conditioner. SAE International Journal of Passenger Vehicle Systems, 2022, 15(2): 91–104.
[13] Zeng X., Huang Y., Song D., et al., Research on modeling and control of fuel cell vehicle integrated thermal management system. SAE International Journal of Passenger Vehicle Systems, 2023, 16(2): 131–146.
[14] Wang H., Meng Y., Zhang Q., et al., MPC-based Precision Cooling Strategy (PCS) for efficient thermal management of automotive air conditioning system. The 3rd IEEE Conference on Control Technology and Applications (CCTA), HongKong, China, 2019.
DOI: 10.1109/CCTA.2019.8920526
[15] Zhang J., Hu X., Luo Y., et al., Effects of rectangular wing vortex generators on the thermal-hydraulic performance of louvered fin and flat tube heat exchanger. Journal of Thermal Science, 2023, 32: 628–642.
[16] Gu X., Shi Q., Gao W., et al., Performance analysis and structural optimization of torsional flow heat exchangers with sinusoidal corrugated baffle. Journal of Thermal Science, 2023, 32: 680–691.
[17] Tuckerman D.B., Pease R.F.W., High-performance heat sinking for VLSI. IEEE Electron Device Letters, 1981, 2(5): 126–129.
[18] Mudawar I., Two-phase microchannel heat sinks: theory, applications, and limitations. Journal of Electronic Packaging, 2011, 133(4): 041002.
[19] Mudawar I., Recent advances in high-flux, two-phase thermal management. Journal of Thermal Science Engineering Applications, 2013, 5(2): 021012.
[20] Wang T., Gao Z., Bai J., et al., Thermal performance of mini cooling channels for high-power servo motor with non-uniform heat dissipation. Journal of Thermal Science, 2023, 32: 650–661.
[21] Shahi P., Deshmukh A., Hurnekar H.Y., et al., Numerical investigation on effect of target coolant delivery in liquid-cooled microchannel heat sinks. Journal of Enhanced Heat Transfer, 2023, 30(1): 35–52.
[22] Ling W., Zhou W., Yua W., et al., Experimental investigation on thermal and hydraulic performance of microchannels with interlaced configuration. Energy Conversion and Management, 2018, 174: 439–452.
[23] Reddy K.V.K., Kumar B.S.P., Gugulothu R., et al., CFD analysis of a helically coiled tube in tube heat exchanger. 5th International Conference of Materials Processing and Characterization: Proceedings, 2017, 4(2): 2341–2349.
[24] Du K., Chen Q., Li Y., et al., Numerical investigation on flow and cooling characteristics of a micro-ribbed vane endwall. Journal of Thermal Science, 2023, 32: 786–799.
[25] Singh H., Ichiyanagi M., Suzuki T., Effect of curvature diameter on secondary flow generation for square channel spiral coil sub-cooled condenser. Society of Automotive Engineers Inc., 2019, SAE Technical Paper 2019-01-2315.
[26] Singh H., Ichiyanagi M., Suzuki T., Influence of coil pitch on thermos-fluid characteristics for square channel spiral coil sub-cooled condenser. International Journal of Automotive Engineering, 2019, 10(3): 266–273.
[27] Castiglione T., Pizzonia F., Piccione R., et al., Detecting the onset of nucleate boiling in internal combustion engines. Applied Energy, 2016, 164(15): 332–340.
[28] Hassan M., Brimmo A., Modeling in-cylinder water injection in a 2-stroke internal combustion engine. Energy Procedia, 2015, 75: 2331–2336.
[29] Ma Y., Xie G., Hooman K., Review of printed circuit heat exchangers and its applications in solar thermal energy. Renewable and Sustainable Energy Reviews, 2022, 155: 111933.
[30] Gao Z., Deng F., Yan D., et al., Thermal performance of thermal management system coupling composite phase change material to water cooling with double s-shaped micro-channels for prismatic lithium-ion battery. Journal of Energy Storage, 2022, 45: 103490.
