Influences of Circular Rib Geometries on the Heat Transfer Characteristics of Supercritical CO2 in Annular Channels: A Numerical Study

DUAN Hangfei, JIN Puhang, XIE Gongnan, XIA Yakang

doi:10.1007/s11630-025-2183-5

2026 , Vol. 35 >Issue 1: 284 - 302

DOI: https://doi.org/10.1007/s11630-025-2183-5

Influences of Circular Rib Geometries on the Heat Transfer Characteristics of Supercritical CO₂ in Annular Channels: A Numerical Study

Expand

1. School of Marine Science and Technology, Northwestern Polytechnical University, Xi’an 710072, China
2. Ocean Institute, Northwestern Polytechnical University, Taicang 215400, China
3. Research Institute of Aero-Engine, Beihang University, Beijing 102206, China

Online published: 2026-01-05

Supported by

SCO₂; annular channel; splitting-rib; heat transfer correlations

Copyright

Science Press, Institute of Engineering Thermophysics, CAS and Springer-Verlag GmbH Germany, part of Springer Nature 2025

Fold

Abstract

To enhance cooling efficiency by supercritical CO₂ in annular structures, this study meticulously explores a rib-splitting strategy. Utilizing Shear Stress Transport (SST) k-ω within ANSYS Fluent, three-dimensional models are developed and simulated, with settings validated against existing experimental data. The investigation focuses on various structural parameters, including the height and position of circular ribs, and the spacing between semicircular ribs. Key findings reveal that a notable enhancement in heat transfer, measured by the comprehensive heat transfer factor, is observed when the rib’s dimensionless height reaches at least 0.25. Closer to the inlet, higher heat transfer performance is achieved, with a dimensionless position of 0.2 exhibiting the best performance across all instances about position effects. The rib-splitting approach has been proven effective in enhancing heat transfer performance, with the comprehensive heat transfer factor increasing progressively with the dimensionless distance and reaching its maximum at a value of 8. The heat transfer enhancement is characterized by an 8.2% increase in the comprehensive heat transfer factor, achieved with a rib’s dimensionless height of 0.5, a dimensionless position of 0.2, and a dimensionless distance of 8. The derived correlations for the Nusselt number (Nu) and friction factor (f) demonstrate the high accuracy of our computational models, as most cases fall within a ±10% deviation range. Crucially, the results advocate for the rib-splitting method’s efficacy in not only enhancing heat dissipation but also in mitigating pressure loss to a significant degree. The insights gained from this study hold considerable promise for thermal management in shafts, potentially elevating both their operational safety and efficiency. The rib-splitting strategy could be a valuable addition to the toolbox of thermal engineers seeking to optimize the performance of their systems.

Key words： SCO₂; annular channel; splitting-rib; heat transfer correlations

Cite this article

DUAN Hangfei, JIN Puhang, XIE Gongnan, XIA Yakang . Influences of Circular Rib Geometries on the Heat Transfer Characteristics of Supercritical CO₂ in Annular Channels: A Numerical Study[J]. Journal of Thermal Science, 2026 , 35(1) : 284 -302 . DOI: 10.1007/s11630-025-2183-5

References

[1] Xie G., Xu X., Lei X., et al., Heat transfer behaviors of some supercritical fluids: A review. Chinese Journal of Aeronautics, 2022, 35(1): 290–306.
[2] Ahn Y., Bae S.J., Kim M., et al., Review of supercritical CO₂ power cycle technology and current status of research and development. Nuclear Engineering and Technology, 2015, 47(6): 647–661.
[3] Binotti M., Astolfi M., Campanari S., et al., Preliminary assessment of sCO₂ cycles for power generation in CSP solar tower plants. Applied Energy, 2017, 204: 1007–1017.
[4] Song J., Wang Y., Wang K., et al., Combined supercritical CO₂ (SCO₂) cycle and organic Rankine cycle (ORC) system for hybrid solar and geothermal power generation: Thermoeconomic assessment of various configurations. Renewable Energy, 2021, 174: 1020–1035.
[5] Zhang X.R., Yamaguchi H., Fujima K., et al., Theoretical analysis of a thermodynamic cycle for power and heat production using supercritical carbon dioxide. Energy, 2007, 32(4): 591–599.
[6] Wu P., Ma Y., Gao C., et al., A review of research and development of supercritical carbon dioxide Brayton cycle technology in nuclear engineering applications. Nuclear Engineering and Design, 2020, 368: 110767.
[7] Li Z., Shi M., Shao Y., et al., Supercritical CO₂ cycles for nuclear-powered marine propulsion: preliminary conceptual design and off-design performance assessment. Journal of Thermal Science, 2024, 33(1): 328–347.
[8] Qin L., Xie G., Ma Y., et al., Thermodynamic analysis and multi-objective optimization of a waste heat recovery system with a combined supercritical/transcritical CO₂ cycle. Energy, 2023, 265: 126332.
[9] Feng F., Li T., An J., et al., Performance assessment of a novel polygeneration system based on the integration of waste plasma gasification, tire pyrolysis, gas turbine, supercritical CO₂ cycle and organic Rankine cycle. Journal of Thermal Science, 2023, 32(6): 2196–2214.
[10] Fairuz Z.M., Jahn I., Abdul-Rahman R., The effect of convection area on the deformation of dry gas seal operating with supercritical CO2. Tribology International, 2019, 137: 349–365.
[11] Yuan T., Yang R., Li Z., et al., Thermal characteristics and cooling effect for SCO₂ dry gas seal with multiple dynamic groove types. Applied Thermal Engineering, 2024, 236: 121896.
[12] Uddin M., Gurgenci H., Guan Z., et al., Design a cooling pillow to support a high-speed supercritical CO₂ turbine shaft. Applied Thermal Engineering, 2021, 196: 117345.
[13] Peeters J.W.R., T’Joen C., Rohde M., Investigation of the thermal development length in annular upward heated laminar supercritical fluid flows. International Journal of Heat and Mass Transfer, 2013, 61: 667–674.
[14] Peeters J.W.R., Pecnik R., Rohde M., et al., Characteristics of turbulent heat transfer in an annulus at supercritical pressure. Physical Review Fluids, 2017, 2(2): 024602.
[15] Qin K., Li D., Huang C., et al., Numerical investigation on heat transfer characteristics of Taylor Couette flows operating with CO₂. Applied Thermal Engineering, 2020, 165: 114570.
[16] Uddin M., Gurgenci H., Klimenko A., et al., Heat transfer analysis of supercritical CO₂ in a high-speed turbine rotor shaft cooling passage. Thermal Science and Engineering Progress, 2023, 39: 101694.
[17] Xiao Y., Pan J., Gu H., Numerical investigation of spacer effects on heat transfer of supercritical fluid flow in an annular channel. International Journal of Heat and Mass Transfer, 2018, 121: 343–353.
[18] Eze C., Wong K.W., Gschnaidtne T., et al., Numerical study of effects of vortex generators on heat transfer deterioration of supercritical water upward flow. International Journal of Heat and Mass Transfer, 2019, 137: 489–505.
[19] Eze C., Lau K.T., Ahmad S., et al., Mitigation of heat transfer deterioration in a circular tube with supercritical CO2 using a novel small-scale multiple vortex generator. International Journal of Thermal Sciences, 2020, 156: 106481.
[20] Gond A.K., Basu D.N., Dalal A., Numerical investigation of heat transfer characteristics of CO₂ in a vertical divergent tapered annular channel. Fluid Mechanics and Fluid Power, 2024, 1: 483–493.
[21] Wong K.W., Cheng H., Zhao J., Numerical study on mitigation of heat transfer deterioration in supercritical CO₂ heat exchanger application. 25th International Conference on Nuclear Engineering, Shanghai, China, 2017, 6: V006T08A104.
DOI: https://doi.org/10.1115/ICONE25-67612.
[22] Yuan H., Edlebeck J., Wolf M., et al., Simulation of supercritical CO₂ flow through circular and annular orifice. Journal of Nuclear Engineering and Radiation Science, 2015, 1(2): 021003.
[23] Xi L., Gao J., Xu L., et al., Study on heat transfer performance of steam-cooled ribbed channel using neural networks and genetic algorithms. International Journal of Heat and Mass Transfer, 2018, 127: 1110–1123.
[24] Xi L., Xu L., Gao J., et al., Numerical analysis and optimization on flow and heat transfer performance of a steam-cooled ribbed channel. Case Studies in Thermal Engineering, 2021, 28: 101442.
[25] Zhang G., Sundén B., Xie G., Combined experimental and numerical investigations on heat transfer augmentation in truncated ribbed channels designed by adopting fractal theory. International Communications in Heat and Mass Transfer, 2021, 121: 105080.
[26] El Maakoul A., Feddi K., Saadeddine S., et al., Performance enhancement of finned annulus using surface interruptions in double-pipe heat exchangers. Energy Conversion and Management, 2020, 210: 112710.
[27] Wang J., Guan Z., Gurgenci H., et al., A comprehensive review on numerical approaches to simulate heat transfer of turbulent supercritical CO2 flows. Numerical Heat Transfer, Part B: Fundamentals, 2020, 77(5): 349–400.
[28] Kim H.Y., Kim H.R., Kang D.J., et al., Experimental investigations on heat transfer to CO₂ flowing upward in a narrow annulus at supercritical pressures. Nuclear Engineering and Technology, 2008, 40(2): 155–162.
[29] Li Y., Sun F., Xie G., et al., Improved thermal performance of cooling channels with truncated ribs for a scramjet combustor fueled by endothermic hydrocarbon. Applied Thermal Engineering, 2018, 142: 695–708.
[30] Li X., Meng J., Li Z., Roughness enhanced mechanism for turbulent convective heat transfer. International Journal of Heat and Mass Transfer, 2011, 54(9–10): 1775–1781.
[31] Wang Z., Guo Q., Wu Y., et al., Frictional resistance investigation of sCO₂ and a semi-empirical friction factor correlation based on wall-of-the-law. International Journal of Heat and Mass Transfer, 2023, 217: 124634.
[32] Jing Q., Xie Y., Zhang D., Thermal hydraulic performance of printed circuit heat exchanger with various channel configurations and arc ribs for SCO₂ Brayton cycle. International Journal of Heat and Mass Transfer, 2020, 150: 119272.

Options

Outlines

模态框（Modal）标题

Journal of Thermal Science

Abstract

Cite this article

References